02 October 2005

Home | Previous | Next

2/10/2005
Partly fitted throttle cable. Made new mounting bracket for cabin end of cable, as the supplied one was too far out from the console, causing lateral force on the cable. Carb end of cable requires 2.5 washers to keep cable in line and also to avoid the pin striking the idle adjustment screw. The return spring on the throttle causes the throttle lever to recoil from idle position. Will ask Jabiru about this.
Glassed outlet of NACA duct, and glassed and flocked a collar onto the oil overflow collector to prvent it falling through its retaining clip. Also flocked a piece of 26 layer plate to the clip to provide clearance from the fiewall.
Flocked forward elevator control stop.

Time: 7 hours
Total Time: 359 hours

Home | Previous | Next